Module 31- Three Pumps Batch process control implementation. Module 30- Two One Way crossing traffic lights control implementation. Module 29- Silo process control application implementation. Module 28- Garage door reversible motor control. Module 27- Tank fill and drain application. Module 26- Analog signal counts and scaling options implementation. Module 25- Big- and Little-Endian swap implementation. Module 24- BCD Input / Output control application. Module 23- BCD user interface ladder implementation FRD and TOD instructions. Module 22- One Way Traffic Lights control. Module 21- Batch Process Control sequence implementation. Module 20- Mary Go Round one timer ladder control implementation. Module 19- Schmitt Trigger control application. Module 18- Light control using one Normally Open (NO) Push Button (PB). Module 17- Math and Move instructions ladder application. Module 16- Count Up and Down ladder application. Module 15- Retentive Timer (RTO) operation and Pump station scheduling application.

Module 14- OFF Delay (TOF) timers, Count UP (CTU), and Count Down (CTD) applications. Module 13- Motor Fail to Start and Gate manipulation in irrigation control application. Module 12- TON applications Mary Go Round, cascading, and recycling. Module 11- ON Delay (TON) Timer control and operation. Module 10- Bit Shift Left (BSL) instruction and sequence control application. Module 09- Bit and Word combinational ladder logic implementation. Module 08- Batch process control structured programming Motors, Heater, and Mixer. Module 07- OSR, Latch, Unlatch Motor start / stop applications. Module 06- Motor control, XIC, XIO, Latch, and Unlatch instructions. Module 04- Maser Control Relay (MCR) and logic diagrams. Module 03- Combinational logic and introduction to LogixPro simulation software. Module 02- PLC Fundamentals hardware and programming basics. Module 01- Hardwired Relay control and the PLC evolution. Free preview for Module 1 and Module 11.Įach Module contains step by step recording, associated MS Word documentation files, and fully debugged ladder logic program implementation. Hands-on with LogixPro 500 simulations software.Ĥ2 Modules - 60 lectures, 44 lectures recording, and over 50 ladder programs.Be able to perform process control design and troubleshooting.Be able to use the SLC-500/5000 advanced instructions.Understand PLC instrumentation and HMI interfaces.Use of Timers / Counters in real time process control applications.Ladder logic programming hands-on with real industrial applications.Realize the characteristic of hardwired and PLC control systems.

Understand PLC hardware and memory architecture.

LogixPro 500 Version, PLC Automation, Eman Kamel, Ph. Hands-On AB Programmable Logic Controller Automation Fundamentals.

2 way traffic light plc in logixpro